Skip to content

The open beta runs until 30 November. From 1 December Volter is paid, and accounts created before 1 December stay free until 31 December. See the prices

Importing an installation

Import an existing single-line diagram or a photo of the board, check what the assistant read and add it to your project.

Importing an existing installation

Do you have an old single-line diagram on paper, a PDF from the previous installer or only the board itself? Let the assistant read it.

  1. Open the menu of the project at the top and choose Import installation. In a project without circuits the button is also in the bar on a wide screen, and on an empty plan on the Nothing drawn yet card.
  2. Drag your files into the window, or click Choose files. A photo, a scan or a PDF, such as jpg or png. At most 12 images at a time.
  3. For a PDF with more pages, Choose the pages opens. Tick the single-line diagram, the floor plan and the photos of the board. A cover page does not have to come along.
  4. Mark for every image what it is: Single-line diagram, Floor plan or Board. If you leave Type: automatic, the assistant works it out by itself. Marking it reads faster and with less doubt.
  5. Click Read. That takes half a minute to a few minutes.

Checking

After reading, your image is on the left and what the assistant read is on the right:

  • The board: the supply, the main RCD, the short-circuit rating and the supply cable.
  • The circuits, per RCD: name, amperage, curve, poles, cable and loads.
  • What is not certain: at the top it says how many fields you have to check. Those fields are highlighted.

This is how you work through the list:

  1. Compare every circuit with the image on the left. If a field was read wrongly, click Edit on the circuit and correct it.
  2. If the amperage or the wire size is missing, fill it in. Without it the circuit does not come along.
  3. Untick a circuit if you do not want to take it over.
  4. If in doubt, ask the assistant in the conversation next to the list. On a narrow screen you open it with Discuss. It can change fields if you ask. You can reverse every change with Put back.
  5. Click Add to the project at the bottom. The button says how many circuits come along.

With Cancel you close the window without taking anything over.

The circuits and the board are now in your project, and Volter opens the single-line diagram. The loads go to To be placed, ready to put on the plan. The assistant knows what it read: you can ask questions about it afterwards.

Only a photo of the board

A photo of the board shows no loads and no cables. The assistant reads the circuit breakers and RCDs. It derives the wire size from the amperage of the circuit breaker. Check it.

With a floor plan

If a floor plan is included and nothing is drawn in your project yet, the assistant can also draw the plan: walls, doors, windows and the symbols it could place. You tick that on or off per floor. Volter says where the scale comes from. If there is no dimension on the sheet, the scale is estimated. Be sure to check the dimensions then.

Importing into a project with circuits

If your project already has circuits, Volter puts the sheet it read next to them. Every circuit says New, Differs or Already there. What is already in your project stays. You choose yourself which new circuits and which differences you take over. The button at the bottom then says how many changes you take over.

Problems

No circuits were found while importing

The image is too blurry, or it holds no single-line diagram or photo of the board. Add a sharper image, on which the inscriptions are readable.

Importing takes too long or the images are too large

Try it with fewer images. Leave out pages that say nothing about the installation, such as a cover page or a report.

A circuit does not come along

The amperage or the wire size is missing. Fill it in on the card of the circuit. If it says Already there, the circuit is the same as the one in your project and there is nothing to take over.

Valid for Volter 1.2.0 · images from 11/15/2026